

Professional Telephone Voice Changer
SPY-shop.dk anvender SSL.
Pakker sendes til Pakkeshop.
Læs mere på forbrug.dk
How does it work?
To start using it first you have to connect the acoustic coupler to the telephone's ear piece
and adjust the settings with the selector, choosing between the 16 levels of distortion and
the male or female voice. Level 0 corresponds to the voice without distortion, from there
you have to adjust the tone until you achieve the desired voice change.
Even your own spouse will not recognize you on this one folks. The high quality acoustic
coupler attaches to the headset and you simply talk into the mic on the unit.
Description:
Professional grade voice changer
Lightweight and compact
Zippered black case
Powered by a 9V battery, not included
Compatible with practically all phones, also with mobiles.
16 levels of voice distortion. At the most extreme levels the voice will sound less naturally.
Male and female voices.
To change the battery you have to slide the back cover of the device, when it is turned off.
Replace it with a 9V battery or cell.
Simply attach the acoustic coupler to your telephones handset, adjust the 16 settings by
turning the selector clockwise.
Operations:
Hold the acoustic coupler against your ear.Turn the unit on by placing the slide switch
to the"NO" position.
Place the selector switch to the center (0) position.
Speak ACROSS(not straight into) the microphone which is locate on the front panel of
the unit. You will hear your natural voice through the acoustic coupler.
Now experiment with different settings of the selector switch:
It has sixteen settings ,Turing clockwise from 0-*-0, in turn. It has seven female voices
and eight male voices,"0" is the natural voice,"*"is the man voice,the"high"settings will
increase the pitch of your voice and the "low"settings will decrease the pitch.
You will notice that you only need to go one or two "steps" up or down in order to get a
good "voice disguise" while preserving a natural quality to you voice.At MO-re extreme
settings your voice will not sound natural.
Connection the Voice Changer to a Telephone:
Place the acoustic coupler against the microphone portion of the handset.
Make sure the holes in the microphone portion of the hand set are fully covered by
the a acoustic coupler. Then wrap the coupler’s strap around the handset and fasten.
Attaching the Coupler to the Handset
While holding the receiver to your ear. Position the handset In such a manner that
the microphone section with attached coupler is angled upward away from you mouth
Turn the voice changer on by placing the slide switch to the "NO" position .
Set the selector switch to the desired position
Speak in a normal tone of voice ACROSS the microphone of the voice changer
(do not speak directly INTO it)
At the end of your call,turn the voice changer off.
Replace the Battery:
Slide the bottom cover off.(see figure 2 below).Replace the battery with a Mallory 9V Duracell or
Eveready 9V Energizer
Use good quality alkaline batteries only.
Engelsk manual